Bike Noob

Because I'm Always Learning Something New

  • Home
  • About
  • Contact
  • Partners

The Most Important Thing: Steve Martin

04.12.2011 by Ray Niekamp // 10 Comments

 

 

 

Steve Martin

 

 

Bike Noob is happy to feature the first in our series of guest posts, “The Most Important Thing.” Our first author is Steve Martin, a relatively new biker from northern Virginia. Steve, a retired military officer and current civil servant, also writes his own blog, There and Back Again.

Last Spring, I returned to the cycling hobby I dabbled in over 15 years ago. Needless to say, there were a great many things I have learned in the past year. If Mr. Niekamp is “The Bike Noob,” then I must be something on the order of “The Bike Incompetent.” Fortunately, I get to pick the name of my own blog and I have taken it in a different direction.

While I am nowhere near an expert on most bicycling subjects, there is one particular area I feel qualified to speak on: flat tires. Many people go months at a time without flatting. Some lucky souls go years at a time. I have managed to get NINE flats in my first 12 months of cycling, seven of those flats in the hell that was June to August, 2010. Each flat was a different lesson.

So I’ve learned a few things about flat tires in the past year, mostly through a series of unfortunate mistakes on my part. I humbly offer these tire-related tips in the hope that others may not need to learn these lessons like I did – the hard way.

1. Don’t skimp on tires. In my view, they’re the most important and potentially the most-easily damaged piece of gear on your bike. A good set of tires will not only help you avoid learning how to change a flat on a hot dusty road, but they will let you ride faster. Spend some extra money on puncture resistant tires and you’ll more than make up the difference in the money saved on spare tubes, repair kits, and the dramatic decrease in frustration.

2. Pump your tires before every ride. I check my car’s tire pressure once every Blue Moon. Do that with your bike and you will suffer. It’s a small thing, but make sure your tires are properly inflated before every ride.

3. Inspect your tires before every ride. Run your hand along their entire length and visually inspect them for bits of glass, nails, staples, etc… that are slowly working their way toward your beloved inner tube. Remove as necessary.

4. Don’t underinflate your tires. Especially if you’re a Clydesdale like Yours Truly. Low pressure invites a “pinch flat,” which is a nasty event because pinch flats almost always immediately lose pressure. There is no “limping home” with a pinch flat, which occurs when the tube is pinched against the rims, usually during a jarring bump, and two holes result.

5. Don’t overinflate your tires.

Remnants of an overinflated innertube explosion

In an effort to avoid a pinch flat and improve rolling resistance, you may be tempted to do this. Don’t. Your tube will explode and the resulting noise will sound very similar to a shotgun blast. When this echoes down the street, concerned neighbors will rush to their fences to see what happened and you will be considerably embarrassed. Trust me on this.

6. Always carry a spare tube and a pump. This almost goes without saying, except I must say that I have violated this rule more than once and flatted while doing so on two occasions. I believe the odds of getting a flat dramatically when you don’t have one or both of these items. Why this occurs is one of Life’s mysteries, but if my experiences are normal then it is an undeniable Truth.

 

 

Twisted tire due to turning inside-out

 

7. Don’t flip your tire inside out. When changing a flat, you may be tempted to flip your tire inside out (and can’t think of a good reason for this right now, but when I was fighting with my tire in 90 degree heat, it seemed like a good idea at the time). Many tires have kevlar beads that hold them in place. If you turn your tire inside out, you will find that the bead twists and cannot easily be returned to its original state. This will cause your tire to be hopelessly askew after you mount it on the wheel. See the attached photo as evidence.

8. Mount your tire so that the valve stem is next to a recognizable part of your tire.

Valve stem over the Bontrager “r”

This way, you can quickly compare a hole in your inner tube to a specific part of the tire and thus identify an foreign objects that are causing punctures.

9. Practice changing tires in the comfort of your own home. Practice makes perfect, or at least it makes you less of a klutz than you would be without it. Put on some nice music, grab a cold beverage of your choice and give it a shot. This is infinitely preferable to learning on the side of a highway in sweltering heat.

10. Consider a CO2 cartridge. Tube-mounted pumps will get the job done, but the last 30 PSI will wear you out. A CO2 cartridge takes seconds. They’re small and easy to store in a saddle bag or jersey pocket. They aren’t necessarily the most intuitive thing you will ever use, so if you decide to go with these, refer to Tip #8.

If you would like to join Steve with a guest post on this blog, write one on the topic: What’s the Most Important thing you’ve learned about cycling? Details available here.

Like this:

Like Loading...

Related

Categories // guest post, Tips, tires Tags // flat tire, guest post

Comments

  1. amazer98 says

    April 13, 2011 at 6:49 am

    Great points, Steve. I would just add the following to your list:
    1. Carefully rub a bunched up glove along the inside of your removed tire to scrape away any sharp objects like thorns or glass shards that might have penetrated and that could puncture the replacement tube. Don’t use your bare hand to do this!
    2. Don’t overtighten the little nut that screws down the valve stem. I made this mistake a few times and noticed my tubes were bursting at the base of the valve. Just lightly finger tighten the nuts.
    3. When inflating tires, position the valve stem so it’s pointing downward from the 12 o’clock position. Push the pump or CO2 fitting straight onto the valve– no twisting. When you are done, grab the end of the pump fitting with your right hand and push hard straight down on your right wrist (with your left hand, of course). This avoids any twisting motion, which can bend or stress the tire valve.

    Hope my $.02 helps!

    Reply
  2. Steve says

    April 13, 2011 at 7:53 pm

    Thanks for the air time, Ray! It’s quite an honor to be on such an informative site as yours. And good tips, Amazer98. I had never heard #3 before. I’ll have to think about that…

    Reply
  3. Clive Chapman says

    April 14, 2011 at 2:29 am

    Eh? I could have sworn I clicked on Bike Noob’s blog to get some words of wisdom, instead… 😉

    Reply
    • Steve says

      April 14, 2011 at 3:49 am

      Very funny, Clive. Very funny. You know, I travel a lot. One of these days I just might make it to Manchester. If that comes to pass, I think I will grab a large stick and walk the tow paths in the pre-dawn light…

      Reply
      • Clive Chapman says

        April 15, 2011 at 1:22 am

        Hell of a walk down a towpath to Birmingham from Manchester mate. You might want to bring your bike and some camping kit!

        Reply
  4. roadtoacenturyandbeyond says

    April 14, 2011 at 3:10 pm

    Very good points. Thanks for the info.

    Reply
  5. aaronwest says

    April 14, 2011 at 6:53 pm

    Good points. I completely agree on upgrading the tires. When I bought my entry level bike with cheapo tires, I seemed to have a flat a week. Since I upgraded, I have yet to have a flat in about 6 months. Unfortunately this isn’t helping with my tire changing practice.

    Reply
  6. Paul says

    April 17, 2011 at 4:05 pm

    All good advice, personally one spare tube is not enough for me, I carry two and a full puncture repair kit, I’ve found that punctures come in twos. There’s nothing worse than being unable to get moving again because you’ve no spares left to repair a puncture. It’s only happened to me once, fortunately I had a great mobile phone app that saved me. I phoned the wife up to come and pick me up. Now I’m a little paranoid about making sure I have enough puncture repair kits in my bag.

    Reply
  7. Chris Thunderfist says

    October 20, 2015 at 3:04 am

    Thanks for tip number 7. I just did this by accident and searched google resulting in landing on this page…while you don’t explain how to fix the issue I was inspired enough that this had happened to someone else to try fixing it. With enough force I was able to turn the twisted tire back into shape within 30 seconds. Yay! A good rabbit never gives up.

    Reply

Leave a ReplyCancel reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Get Email Updates

Enter your email address to subscribe to this blog and receive notifications of new posts by email.

Join 257 other subscribers

Categories

  • Accessories
  • Bike fit
  • Bikes
  • Blogging
  • Books
  • clubs
  • Cold weather
  • Community
  • Commuting
  • Components
  • crash
  • cycling
  • Equipment
  • Favorite rides
  • fitness
  • food
  • guest post
  • Heat
  • Injury
  • logs
  • Maintenance
  • Mental
  • Nutrition
  • Odds 'n ends
  • People
  • Poll
  • Racing
  • Records & stats
  • Review
  • Rides
  • running
  • Safety
  • soreness
  • Specialized
  • Technique
  • Technology
  • Tips
  • tires
  • training
  • Travel
  • Uncategorized
  • Home
  • About
  • Contact
  • Partners

Recent Posts

  • Getting Back on the Bike: Road Cycling Tips for Older Cyclists
  • Are BCAAs and EAAs Good for Cycling?
  • How to Fix Numb Toes When Cycling
  • How to Find and Vet a Bike Club
  • Celebrate Pearl Izumi with Big Savings in the Memorial Day Sale

Categories

  • Accessories
  • Bike fit
  • Bikes
  • Blogging
  • Books
  • clubs
  • Cold weather
  • Community
  • Commuting
  • Components
  • crash
  • cycling
  • Equipment
  • Favorite rides
  • fitness
  • food
  • guest post
  • Heat
  • Injury
  • logs
  • Maintenance
  • Mental
  • Nutrition
  • Odds 'n ends
  • People
  • Poll
  • Racing
  • Records & stats
  • Review
  • Rides
  • running
  • Safety
  • soreness
  • Specialized
  • Technique
  • Technology
  • Tips
  • tires
  • training
  • Travel
  • Uncategorized

Archives

  • May 2024
  • December 2023
  • November 2023
  • March 2022
  • October 2020
  • November 2018
  • May 2018
  • September 2017
  • November 2016
  • October 2016
  • January 2016
  • July 2015
  • June 2015
  • May 2015
  • April 2015
  • March 2015
  • February 2015
  • January 2015
  • December 2014
  • November 2014
  • October 2014
  • September 2014
  • August 2014
  • July 2014
  • June 2014
  • May 2014
  • April 2014
  • March 2014
  • February 2014
  • January 2014
  • December 2013
  • November 2013
  • October 2013
  • September 2013
  • August 2013
  • July 2013
  • June 2013
  • May 2013
  • April 2013
  • March 2013
  • February 2013
  • January 2013
  • December 2012
  • November 2012
  • October 2012
  • September 2012
  • August 2012
  • July 2012
  • June 2012
  • May 2012
  • April 2012
  • March 2012
  • February 2012
  • January 2012
  • December 2011
  • November 2011
  • October 2011
  • September 2011
  • August 2011
  • July 2011
  • June 2011
  • May 2011
  • April 2011
  • March 2011
  • February 2011
  • January 2011
  • December 2010
  • November 2010
  • October 2010
  • September 2010
  • August 2010
  • July 2010
  • June 2010
  • May 2010
  • April 2010
  • March 2010
  • February 2010
  • January 2010
  • December 2009
  • November 2009
  • October 2009
  • September 2009
  • August 2009
  • July 2009
  • June 2009
  • May 2009
  • April 2009
  • March 2009
  • February 2009
  • January 2009
  • December 2008
  • November 2008
  • October 2008
  • September 2008
  • August 2008
  • July 2008
  • June 2008
  • May 2008
  • April 2008
  • March 2008
  • February 2008

Copyright © 2026 · Modern Studio Pro Theme on Genesis Framework · WordPress · Log in

Go to mobile version
%d