Bike Noob

Because I'm Always Learning Something New

  • Home
  • About
  • Contact
  • Partners

‘Tis the Season For Flats

10.04.2011 by Ray Niekamp // 4 Comments

I always have figured flats can happen anytime. But for guest poster Don Blount, this is the busy season.

It is harvest season in the Lodi Appellation, which is the fancy name for the federally designated American Viticulture Area in this part of California’s Central Valley.

In 2010 that area produced some 546,000 tons of grapes. Winegrapes are the No. 2 cash crop here in San Joaquin County, trailing only milk if you were wondering. And you can find some 60 wineries in the area.

The vineyards look pretty, but flats lurk here.

So what does any of this have to do with biking?

Well, I ride my bike in that area a lot as it has roads conducive to cycling most of the time. But when grape harvest begins, so does flat tire season. I was out for a ride recently not having experienced a flat in about six months and I had two flats during the same 25-mile ride. The first flat happened about five miles into the ride and was caused by a long piece of metal that stuck in the rear tire. I was up and running again in less than 10 minutes.

The second flat was noticeable about a half mile from home. It was caused by a sticker that I picked up somewhere along the way. The tire was soft but not completely flat so I was able to nurse it home. I changed the tube later that night and patched it along with three others I had in my garage.

During the harvest all types of debris gets moved out of the fields and onto the road including goatheads, thorns, pieces of metal and all types of other crap. It was during the 2010 harvest season that during one group ride we had roughly a dozen.

I like grapes, I like wine, but I do not like flats.

The dreaded harvest equipment.

There are certain roads I will avoid if I see a lot of harvesting equipment in that area. But it is inevitable that flats will happen.

Still, I do what I can to minimize the number I get. Itry make sure my tires are in good condition, I check them after every ride, wiping them down with a wet cloth and looking for any cuts or things sticking in the tire. There have been times I have found something poking in the tire that has not reached the tube but would have eventually caused a flat if it was not removed.

And when riding, I carry along two spare tubes, three C02 cartridges and a pump. If I don’t use them, I may be able to help someone in need. I would rather carry a little extra weight and be overly cautious rather than stuck on the side of the road because of a flat.

Like this:

Like Loading…

Categories // tires Tags // flat tire

Fixing Flats Faster

08.30.2011 by Ray Niekamp // 14 Comments

I’ve always considered myself to be pretty competent when it comes to fixing flats. I’ve had enough of them that, while they will be forever a pain in the patootie, they don’t ruin my ride like they might have done several years ago.

But my confidence in my flat fixing ability was challenged earlier this month, when I had a spate of them within a relatively short time. I had three flats in two weeks. It turns out that my rear tire had worn so badly, the cords showed through in two places.

What vexes me is this: I take too long to fix flat tires.

I think I go about it just as most other folks would. I shift into the smallest cog and the smallest chainring, then take off the wheel. My seatbag contains three tire levers, and I usually need only two to get the tire out of the rim. I’ll pull the tube out, keeping the other side of the tire inside the rim, then I feel around inside the tire to see if I can find any bits of glass or metal or whatever that might have caused the flat.

I take the replacement tube from the seatbag, and blow a little air into the valve to give the tube a little shape, then fit it inside the tire. Once I’ve got the tube inside, it’s time to grab the part of the tire that’s outside the rim and pop it back in. As always, I have a little trouble getting the last three inches of the tire over the rim, so sometimes I’ll use one of the tire levers to help with that (Yes, I know — could cause a puncture in the tube). Pump up the tire, put it back on the bike, clean up after myself, and I’m off.

I can do this in five minutes. Well, I have done it in five minutes maybe once. More often, it takes 15 minutes. But when I had the flats this past month, I noticed it took me a full half hour to get underway again.

What gives?

I can’t pinpoint the exact cause of my slowness. But two weekends ago I realized that tire changing was not being done as efficiently as in the past. Whatever the cause, I have to get quicker at the whole roadside repair routine, so I can get moving again quicker.

I suppose I could practice, and build my speed that way. Have you ever practiced fixing flats? (Okay, when I started biking seriously a few years ago, I really did practice it — but only once, and never since.) But really, I’d rather wait until faced with the real thing before I dirty my hands doing that chore.

So, readers — I’m asking for help. What kind of techniques do you use to fix a flat quickly and get out on the road where we wanted to be in the first place. What’s the best part of the routine to cut the amount of time I would spend getting the tire changed?

Like this:

Like Loading…

Categories // tires Tags // flat tire

The Most Important Thing: Steve Martin

04.12.2011 by Ray Niekamp // 10 Comments

 

 

 

Steve Martin

 

 

Bike Noob is happy to feature the first in our series of guest posts, “The Most Important Thing.” Our first author is Steve Martin, a relatively new biker from northern Virginia. Steve, a retired military officer and current civil servant, also writes his own blog, There and Back Again.

Last Spring, I returned to the cycling hobby I dabbled in over 15 years ago. Needless to say, there were a great many things I have learned in the past year. If Mr. Niekamp is “The Bike Noob,” then I must be something on the order of “The Bike Incompetent.” Fortunately, I get to pick the name of my own blog and I have taken it in a different direction.

While I am nowhere near an expert on most bicycling subjects, there is one particular area I feel qualified to speak on: flat tires. Many people go months at a time without flatting. Some lucky souls go years at a time. I have managed to get NINE flats in my first 12 months of cycling, seven of those flats in the hell that was June to August, 2010. Each flat was a different lesson.

So I’ve learned a few things about flat tires in the past year, mostly through a series of unfortunate mistakes on my part. I humbly offer these tire-related tips in the hope that others may not need to learn these lessons like I did – the hard way.

1. Don’t skimp on tires. In my view, they’re the most important and potentially the most-easily damaged piece of gear on your bike. A good set of tires will not only help you avoid learning how to change a flat on a hot dusty road, but they will let you ride faster. Spend some extra money on puncture resistant tires and you’ll more than make up the difference in the money saved on spare tubes, repair kits, and the dramatic decrease in frustration.

2. Pump your tires before every ride. I check my car’s tire pressure once every Blue Moon. Do that with your bike and you will suffer. It’s a small thing, but make sure your tires are properly inflated before every ride.

3. Inspect your tires before every ride. Run your hand along their entire length and visually inspect them for bits of glass, nails, staples, etc… that are slowly working their way toward your beloved inner tube. Remove as necessary.

4. Don’t underinflate your tires. Especially if you’re a Clydesdale like Yours Truly. Low pressure invites a “pinch flat,” which is a nasty event because pinch flats almost always immediately lose pressure. There is no “limping home” with a pinch flat, which occurs when the tube is pinched against the rims, usually during a jarring bump, and two holes result.

5. Don’t overinflate your tires.

Remnants of an overinflated innertube explosion

In an effort to avoid a pinch flat and improve rolling resistance, you may be tempted to do this. Don’t. Your tube will explode and the resulting noise will sound very similar to a shotgun blast. When this echoes down the street, concerned neighbors will rush to their fences to see what happened and you will be considerably embarrassed. Trust me on this.

6. Always carry a spare tube and a pump. This almost goes without saying, except I must say that I have violated this rule more than once and flatted while doing so on two occasions. I believe the odds of getting a flat dramatically when you don’t have one or both of these items. Why this occurs is one of Life’s mysteries, but if my experiences are normal then it is an undeniable Truth.

 

 

Twisted tire due to turning inside-out

 

7. Don’t flip your tire inside out. When changing a flat, you may be tempted to flip your tire inside out (and can’t think of a good reason for this right now, but when I was fighting with my tire in 90 degree heat, it seemed like a good idea at the time). Many tires have kevlar beads that hold them in place. If you turn your tire inside out, you will find that the bead twists and cannot easily be returned to its original state. This will cause your tire to be hopelessly askew after you mount it on the wheel. See the attached photo as evidence.

8. Mount your tire so that the valve stem is next to a recognizable part of your tire.

Valve stem over the Bontrager “r”

This way, you can quickly compare a hole in your inner tube to a specific part of the tire and thus identify an foreign objects that are causing punctures.

9. Practice changing tires in the comfort of your own home. Practice makes perfect, or at least it makes you less of a klutz than you would be without it. Put on some nice music, grab a cold beverage of your choice and give it a shot. This is infinitely preferable to learning on the side of a highway in sweltering heat.

10. Consider a CO2 cartridge. Tube-mounted pumps will get the job done, but the last 30 PSI will wear you out. A CO2 cartridge takes seconds. They’re small and easy to store in a saddle bag or jersey pocket. They aren’t necessarily the most intuitive thing you will ever use, so if you decide to go with these, refer to Tip #8.

If you would like to join Steve with a guest post on this blog, write one on the topic: What’s the Most Important thing you’ve learned about cycling? Details available here.

Like this:

Like Loading…

Categories // guest post, Tips, tires Tags // flat tire, guest post

  • « Previous Page
  • 1
  • …
  • 3
  • 4
  • 5
  • 6
  • 7
  • …
  • 11
  • Next Page »

Get Email Updates

Enter your email address to subscribe to this blog and receive notifications of new posts by email.

Join 257 other subscribers

Categories

  • Accessories
  • Bike fit
  • Bikes
  • Blogging
  • Books
  • clubs
  • Cold weather
  • Community
  • Commuting
  • Components
  • crash
  • cycling
  • Equipment
  • Favorite rides
  • fitness
  • food
  • guest post
  • Heat
  • Injury
  • logs
  • Maintenance
  • Mental
  • Nutrition
  • Odds 'n ends
  • People
  • Poll
  • Racing
  • Records & stats
  • Review
  • Rides
  • running
  • Safety
  • soreness
  • Specialized
  • Technique
  • Technology
  • Tips
  • tires
  • training
  • Travel
  • Uncategorized
  • Home
  • About
  • Contact
  • Partners

Recent Posts

  • Getting Back on the Bike: Road Cycling Tips for Older Cyclists
  • Are BCAAs and EAAs Good for Cycling?
  • How to Fix Numb Toes When Cycling
  • How to Find and Vet a Bike Club
  • Celebrate Pearl Izumi with Big Savings in the Memorial Day Sale

Categories

  • Accessories
  • Bike fit
  • Bikes
  • Blogging
  • Books
  • clubs
  • Cold weather
  • Community
  • Commuting
  • Components
  • crash
  • cycling
  • Equipment
  • Favorite rides
  • fitness
  • food
  • guest post
  • Heat
  • Injury
  • logs
  • Maintenance
  • Mental
  • Nutrition
  • Odds 'n ends
  • People
  • Poll
  • Racing
  • Records & stats
  • Review
  • Rides
  • running
  • Safety
  • soreness
  • Specialized
  • Technique
  • Technology
  • Tips
  • tires
  • training
  • Travel
  • Uncategorized

Archives

  • May 2024
  • December 2023
  • November 2023
  • March 2022
  • October 2020
  • November 2018
  • May 2018
  • September 2017
  • November 2016
  • October 2016
  • January 2016
  • July 2015
  • June 2015
  • May 2015
  • April 2015
  • March 2015
  • February 2015
  • January 2015
  • December 2014
  • November 2014
  • October 2014
  • September 2014
  • August 2014
  • July 2014
  • June 2014
  • May 2014
  • April 2014
  • March 2014
  • February 2014
  • January 2014
  • December 2013
  • November 2013
  • October 2013
  • September 2013
  • August 2013
  • July 2013
  • June 2013
  • May 2013
  • April 2013
  • March 2013
  • February 2013
  • January 2013
  • December 2012
  • November 2012
  • October 2012
  • September 2012
  • August 2012
  • July 2012
  • June 2012
  • May 2012
  • April 2012
  • March 2012
  • February 2012
  • January 2012
  • December 2011
  • November 2011
  • October 2011
  • September 2011
  • August 2011
  • July 2011
  • June 2011
  • May 2011
  • April 2011
  • March 2011
  • February 2011
  • January 2011
  • December 2010
  • November 2010
  • October 2010
  • September 2010
  • August 2010
  • July 2010
  • June 2010
  • May 2010
  • April 2010
  • March 2010
  • February 2010
  • January 2010
  • December 2009
  • November 2009
  • October 2009
  • September 2009
  • August 2009
  • July 2009
  • June 2009
  • May 2009
  • April 2009
  • March 2009
  • February 2009
  • January 2009
  • December 2008
  • November 2008
  • October 2008
  • September 2008
  • August 2008
  • July 2008
  • June 2008
  • May 2008
  • April 2008
  • March 2008
  • February 2008

Copyright © 2026 · Modern Studio Pro Theme on Genesis Framework · WordPress · Log in

Go to mobile version
%d